Lenze 9400 - Manual (Page 89)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
89
4 Drive interface
4.2 Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.39 Save cam data
This function extension is available from software version V3.0!
The C00002 = "502: Save cam data" device command serves to save the cam data available in the
main memory of the controller with mains failure protection in the memory module.
[4-23] "Save cam data" function
• This function is executed in the background and is also possible when the controller is enabled
and the application is running.
• However, this function is only executed if valid cam data are available.
• The cam data can also be saved if previously no cam data have been available on the memory
module.
• While the function is executed, no online change and no change of the cam data via parameters
can be carried out.
For software versions lower than V4.0 the following applies:
• If the cam data are provided with an access protection, the user password has to be entered in
C02900 first.
The following applies from software version V4.0:
• For saving the cam data, you do not need to enter a possibly existing user password ( C02900 ).

Tip!
Detailed information on the access protection can be found in the chapter "Basic drive
functions", subchapter " Cam data management ". ( 552)
9400
RAM Memory module MM
Cam data Cam data
Cam application