Lenze 9400 - Manual (Page 726)

14 Parameter reference
14.2 Parameter list | C00003
726
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3342336 Device command executed successfully 51: Identify pole position (360°)
3342337 General fault
3376386 Device command in process
3382023 Pole position identification cannot be executed because
of wrong motor type (asynchronous motor).
3382024 Pole position identification has been aborted
3382025 Pole position identification cannot be executed because
another identification is already active.
3382026 Identification of pole position cannot be executed
because U-rotation or I-rotation test mode is active.
3382027 Identification of pole position cannot be executed
because current controller optimisation mode is active.
3382033 Pole position identification cannot be executed because
the motor is blocked (e.g. by a mechanical brake), a
motor phase is not connected, or a phase shifter is in the
motor cable.
3382047 Pole position identification cannot be executed because
an error or trouble is active.
3382065
From software version
V3.0
Pole position identification cannot be executed because
either the entire motor or a motor phase is not
connected.
3407872 Device command executed successfully 52: Identify pole position (min.
motion)
3407873 General fault
3441922 Device command in process
3447559 Pole position identification cannot be executed because
of wrong motor type (asynchronous motor).
3447560 Pole position identification has been aborted
3447561 Pole position identification cannot be executed because
another identification is already active.
3447562 Identification of pole position cannot be executed
because U-rotation or I-rotation test mode is active.
3447563 Identification of pole position cannot be executed
because current controller optimisation mode is active.
3447569
From software version
V4.0
Pole position identification cannot be executed because
the motor is blocked (e.g. by a mechanical brake), a
motor phase is not connected, or a phase shifter is in the
motor cable.
3447583 Pole position identification cannot be executed because
an error or trouble is active.
3447597 Identification of pole position cannot be executed
because the rotor has moved too strongly.
3447601
From software version
V3.0
Pole position identification cannot be executed because
either the entire motor or a motor phase is not
connected.
Status Meaning Device command