Lenze 9400 - Manual (Page 521)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
521
11 Basic drive functions
11.12 Brake control
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.12.2 Parameter setting
• Parameterisation dialog in »Engineer«: Tab Application parameters  Dialog level Overview 
All basic functions  Brake control
• Short overview of parameters for brake control:
BRK_bError
C02609/8 | BOOL
Status signal "Brake error"
TRUE An error has been detected.
BRK_bCInhActive
C02609/9 | BOOL
Status signal "Controller inhibit"
TRUE Controller inhibit has been set by brake control.
Identifier
DIS code | data type
Value/meaning

Danger!
For the correct function of the brake control the different delay times in the following
parameters have to be set correctly!
If the delay times are set incorrectly, a faulty control of the motor holding brake may be
caused!
In the case of the basic functions
Manual job, encoderless ( 407) and Pole position
identification ( 570) , the number of available operating modes of the holding brake is
limited. Please refer to the danger notes in the chapters indicated.
Parameter Info
C02580 Operating mode brake
C02581 Threshold - brake activation
C02582 Brake resp. to pulse inhibit
C02583 Status input monitoring
C02585 Brake control polarity
C02586 Starting torque 1
C02587 Starting torque 2
C02588 Source of starting torque
C02589 Brake closing time
C02590 Brake opening time
C02591 Waiting time - status monitoring
C02593 Waiting time - brake activation
C02594 Test torque
C02595 Permissible angle of rotation
C02596 Grinding speed
C02597 Accel./decel. time - grinding
C02598 Grinding ON time
C02599 Grinding OFF time
C02600 Acceleration time feedf. control
C02601 Reference for acceleration time of brake