Lenze 9400 - Manual (Page 638)

13 Diagnostics & fault analysis
13.7 Error messages of the operating system
638
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Pointer access in impermissible memory area [0x006a0012]
Application has started [0x006a0013]
Application has stopped [0x006a0014]
PDO mapping (MXI1): Faulty configuration [0x006a0015]
Module ID (decimal) Error ID (decimal)
106: Runtime environment for IEC 61131-3 programs 18
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An invalid pointer access to a protected area occurred in
the application.
Replace application.
Module ID (decimal) Error ID (decimal)
106: Runtime environment for IEC 61131-3 programs 19
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The application in the controller has been started. - (Information only)
Module ID (decimal) Error ID (decimal)
106: Runtime environment for IEC 61131-3 programs 20
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The application in the controller has been stopped. - (Information only)
Module ID (decimal) Error ID (decimal)
106: Runtime environment for IEC 61131-3 programs 21
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
CANopen communication module in MXI1: Incorrectly
configured process data mapping.
• The corresponding PDO channel is not installed, e. g.
because no communication module was selected for
module slot MXI1 in the Engineer project.
• The communication module selected for module slot
MXI1 in the Engineer project does not support PDO
mapping.
• The mapping information downloaded to the
controller is faulty.
• Integrate suitable communication module for
module slot MXI1 in the Engineer project.
• Check the configuration of the network. Then
recompile the project and transmit it to the controller.