16 enable controller, Enable controller, 4drive interface – Lenze 9400 User Manual
Page 61
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
61
4
Drive interface
4.2
Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.16
Enable controller
The
= "42: Enable controller" device command is used to re-enable an inhibited controller.
Tip!
This device command can also be activated via the
icon in the Toolbar.
Related device commands
Note!
Please note that the controller will only be enabled if all sources for controller inhibit are
reset!
•
provides a bit coded representation of all active sources/triggers of a
controller inhibit.
This device command has no status display in
, i.e. the display remains
unchanged showing the previous device command status.