Lenze 9400 - Manual (Page 62)

4 Drive interface
4.2 Device commands
62
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.17 Reset error
The C00002 = "43: Reset error" device command is used to acknowledge an error message if the
error cause has been eliminated and the error is thus no longer pending.

Tip!
An error message can also be acknowledged by activating the Reset error button in the
Diagnostics tab.
Further information on error messages can be found in the chapter "
Diagnostics & fault
analysis ". ( 598)

Note!
This device command has no status display in C00003 , i.e. the display remains
unchanged showing the previous device command status.