13 restart program, Restart program, 4drive interface – Lenze 9400 User Manual
Page 57
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
57
4
Drive interface
4.2
Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.13
Restart program
The
= "35: Restart program" device command is used to restart the application program in
the controller.
• All variables except the RETAIN variables are reset to their initialisation value.
• The situation corresponds to a power failure or switching the controller off/on (warm start)
while the program is running.
Possible status displays for this device command
Related device commands
Status (
Meaning
2327810 Device command in process
2293760 Device command executed successfully
2293761 General fault