Lenze 8400 - Manual (Page 961)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
961
16 Parameter reference
16.2 Parameter list | C00985
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00985
C00986
C00987
C00988
C00990
Parameter | Name:
C00985 | SLVC: Field current controller gain
Data type: INTEGER_16
Index: 23590
d
= 5C26
h
Gain of the direct-axis current difference (Id) between setpoint and actual current for the voltage model of the
sensorless vector control ( SLVC )
• The gain should be selected in a range of 0 ...1 %.
Setting range (min. value | unit | max. value) Lenze setting
0.00 % 20.00 0.50 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00986 | SLVC: Cross current controller gain
Data type: INTEGER_16
Index: 23589
d
= 5C25
h
Gain of the cross current difference for the voltage model of the sensorless vector control ( SLVC )
Setting range (min. value | unit | max. value) Lenze setting
0.00 % 20.00 0.00 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00987 | Inverter motor brake: nAdd
Data type: INTEGER_16
Index: 23588
d
= 5C24
h
Speed lift which is connected in pulses to the brake rampe when the motor is braked.
 Inverter motor brake
Setting range (min. value | unit | max. value) Lenze setting
0 rpm 1000 80 rpm
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00988 | Inverter motor brake: PT1 filter time
Data type: INTEGER_16
Index: 23587
d
= 5C23
h
PT1 filter time for smoothing the speed lift which is added in pulses ( C00987 )
 Inverter motor brake
Setting range (min. value | unit | max. value) Lenze setting
0.0 ms 100.0 0.0 ms
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00990 | Flying restart fct.: Activation
Data type: UNSIGNED_8
Index: 23585
d
= 5C21
h
Switch on/activate flying restart circuit for non-feedback drive systems
 Flying restart fct.
Selection list (Lenze setting printed in bold)
0 Off
1 On
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1