Lenze 8400 - Manual (Page 258)

5 Motor control (MCTRL)
5.11 Encoder/feedback system
258
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to get to the parameterisation dialog of the encoder/feedback system:
1. In the »Engineer«, go to Project view and select the 8400 controller.
2. Select the Application parameters tab from the Workspace.
3. Go to the Overview dialog level and click the following button:
4. Go to the Overview  Motor data dialog level and click the Encoder/Feedback system...
button.
Parameterisation dialog in the »Engineer«
• If an SSI encoder is connected to the synchronous serial interface (SSI):
Use the SSI configuration... button to get to the settings for the SSI encoder evaluation . ( 266)