Lenze 8400 - Manual (Page 1066)

16 Parameter reference
16.2 Parameter list | C02865
1066
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02865
Parameter | Name:
C02865 | MCTRL: Special settings
Data type: UNSIGNED_16
Index: 21710
d
= 54CE
h
From version 12.00.00
Activation of special functions of the internal motor control
Setting range
(min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 No TorqueLimit if TorquemodeOn From version 12.00.00 onwards : If sensorless vector
control ( SLVC ) or servo control ( SC ) are used, in the
"torque control with speed limitation" mode the torque
limitation via nTorqueMotLimit_a and
nTorqueGenLimit_a is also active to limit the torque
setpoint.
• If you want to deactivate the torque limitation to
retain the former function, set bit 0 to "1".
Bit 1 250ms IMP before DCB
Bit 2 1000ms IMP before DCB
Bit 3 DCB: Current controller and C036
app. to C088
Bit 4 Motorident.: No calculation C73 C75
C76 C77 C78
From version 12.00.00 onwards : Following successful
motor parameter identification, the current controller
and field controller parameters are calculated as well.
• If these parameters are not to be calculated, bit 4
must be set to "1".
 Automatic motor data identification
Bit 5 Motorident.: Calculation C70 C71
C72
From version 12.00.00 onwards : Following successful
motor parameter identification, the speed controller
parameters can automatically be calculated as well.
• If these parameters are to be calculated, bit 5 must be
set to "1".
 Automatic motor data identification
Bit 6 Motorident.: Calculation C11 C22
C497 C966 C982
From version 12.00.00 onwards : Following successful
motor parameter identification, further controller
parameters can be calculated automatically.
• If these parameters are to be calculated, bit 6 must be
set to "1".
 Automatic motor data identification
Bit 7 Reserved
Bit 8 DC-bus supply with DC charging
connection
Bit 9 Inverter characteristics inactive
Bit 10 SCPSM: Extrapolation - actual speed
value inactive
Bit 11 TopLine: Speed encoder signal cycle
500us
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Lenze setting Info
C02865/1 0x0000 MCTRL : Special settings
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT