Lenze 8400 - Manual (Page 736)

16 Parameter reference
16.1 Structure of the parameter descriptions
736
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
16.1.3.4 Parameters with subcodes
Description structure
Parameter setting in the »Engineer«
The »Engineer« parameter list displays each subcode individually. The parameters are set as
described in the previous chapters.
16.1.4 Parameter attributes
The table footers contain the parameter attributes:
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Setting range
(min. value | unit | max. value)
Subcodes Lenze setting
Cxxxxx/1
Cxxxxx/2
Cxxxxx/3
Cxxxxx/4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Attribute Meaning
 Read access Read access to parameter possible.
 Write access Write access to parameter possible.
• Please also observe the following attributes:
 CINH Parameter value can only be changed when the controller is
inhibited.
 PLC STOP Parameter value can only be changed when the application is
stopped.
 No transfer Parameter is not transferred to controller when the command Download parameter set is
executed.
 COM Communication-relevant parameter
• This parameter is relevant for parameter data transfer via the (CAN) system bus.
 MOT Motor control parameters