Lenze 8400 - Manual (Page 316)

6 I/O terminals
6.1 Digital terminals
316
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.1.1.4 Reconfiguring DI3(4) to output DO1(2)
Pin 2 and pin 4 of the socket X42 can be used as digital inputs or outputs.
Parameterisation dialog in the »Engineer«:
After the reconfiguration, the outputs DO1/DO2 are displayed with the corresponding parameters
on the Terminal assignment tab instead of the inputs DI3/DI4:
• In the Lenze setting, both pins are configured as digital
input (DI3 and DI4).
• In order to reconfigure the function assignment, set the
corresponding selection in C00116 (see the following
table).
Active function assignment
Setting C00116: DI3 DI4 DO1 DO2
0 DI3 DI4 active; DO1 DO2 inactive  
1 DO1 DI4 active; DI3 DO2 inactive  
2 DI3 DO2 active; DO1 DI4 inactive  
3 DO1 DO2 active; DI3 DI4 inactive  
', '2
', '2
',
'2
&
;
',
'2