Lenze 8400 - Manual (Page 739)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
739
16 Parameter reference
16.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Subcodes Lenze setting Info
C00002/1 0: Off / ready Load Lenze setting
• All parameters are reset to the Lenze setting.
• Only possible when the controller is inhibited.
C00002/2 0: Off / ready Reserved
C00002/3 0: Off / ready Reserved
C00002/4 0: Off / ready Reserved
C00002/5 0: Off / ready Reserved
C00002/6 0: Off / ready Load all parameter sets
• All parameter sets are loaded by the memory module.
• Only possible when the controller is inhibited.
C00002/7 0: Off / ready Reserved
C00002/8 0: Off / ready Reserved
C00002/9 0: Off / ready Reserved
C00002/10 0: Off / ready Reserved
C00002/11 0: Off / ready Save all parameter sets
• All parameter sets are saved to the memory module
safe against mains failure.
C00002/12 0: Off / ready Reserved
C00002/13 0: Off / ready Reserved
C00002/14 0: Off / ready Reserved
C00002/15 0: Off / ready Reserved
C00002/16 1: On / start Enable controller
"1" ≡ Enable controller
"0" ≡ Inhibit controller
C00002/17 0: Off / ready Activate quick stop
"1" ≡ Activate quick stop
"0" ≡ Deactivate quick stop
C00002/18 0: Off / ready Reserved
C00002/19 0: Off / ready Reset error
• After the reset (acknowledgement) of the current
error, further errors may be pending which must also
be reset.
• The status determining error is displayed in C00168 .
• The current error is displayed in C00170 .
C00002/20 0: Off / ready Reserved
C00002/21 0: Off / ready Delete logbook
• All entries in the logbook of the controller are deleted.
• In the logbook, information on the error history is
saved.
C00002/22 0: Off / ready Reserved
C00002/23 0: Off / ready Identify motor parameter (ASM)
• This device command serves to carry out automatic
motor parameter identification.
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
• In order to identify the motor parameters, the
controller must be enabled after this device
command.
 Automatic motor parameter identification
C00002/24 0: Off / ready Reserved
C00002/25 0: Off / ready Reserved
Parameter | Name:
C00002 | Device command
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h