Lenze 8400 - Manual (Page 471)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
471
8 Basic drive functions (MCK)
8.4 Basic settings
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Blocking zone for "absolute (Cw)" and "absolute (Ccw)"positioning modes
Set a blocking zone in
C01245/2 for the "absolute (Cw)" and "absolute (Ccw)" positioning modes in
which no target positions are approached. This blocking zone around the current setpoint position
serves to consider drift motions of the shaft in case of controller inhibit/enable cycles in order to
prevent e.g. an unwanted motion by one cycle.
[8-13] Definition of the blocking zone
Display of the target position in the "Positioning" mode

Stop!
Target positions in the set blocking zone are always approached with the shortest
possible distance in the "absolute (Cw)" and "absolute (Ccw)" positioning modes!
If the blocking zone is too large, the drive may travel to the opposite direction!
• Target positions outside the blocking zone are approached
with the selected positioning mode.
• The blocking zone is limited internally to half the cycle.
ƒƒ
ƒ
ƒ
ƒ
ƒ
&
Positioning mode Target position displayed in C01210/6 in [units]
Absolute (shortest path) Defined position
absolute (Cw) Defined position
absolute (Ccw) Defined position
Continuous 214748.3647
Relative Modulo position + defined position