Lenze 8400 - Manual (Page 765)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
765
16 Parameter reference
16.2 Parameter list | C00107
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00107
C00114
Parameter | Name:
C00107 | DC braking: Hold time
Data type: UNSIGNED_32
Index: 24468
d
= 5F94
h
Maximum hold time of the manual DC injection brake
• A time can be set here after which the DC injection brake is switched off automatically to prevent the motor from
thermal overload.
 DC-injection braking
Setting range
(min. value | unit | max. value)
Lenze setting
0.000 s 999.000 999.000 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00114 | DigInX: Inversion
Data type: UNSIGNED_16
Index: 24461
d
= 5F8D
h
The polarity of each digital input of the device can be inverted via this bit field.
 Digital terminals
Setting range (min. hex value | max. hex value) Lenze setting
0x0000 0xFFFF 0x0000 (decimal: 0)
Value is bit-coded: ( = bit set) Info
Bit 0  Invert. DI1 Inversion of digital input 1
Bit 1  Invert. DI2 Inversion of digital input 2
Bit 2  Invert. DI3 Inversion of digital input 3
Bit 3  Invert. DI4 Inversion of digital input 4
Bit 4  Invert. DI5 Inversion of digital input 5
Bit 5  Invert. DI6 Inversion of digital input 6
Bit 6  Reserved
Bit 7  Reserved
Bit 8  Reserved
Bit 9  Reserved
Bit 10  Reserved
Bit 11  Reserved
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  Invert CInh
Inversion of digital input RFR (controller enable)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT