Lenze 8400 - Manual (Page 134)

5 Motor control (MCTRL)
5.1 Motor selection/Motor data
134
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.1.2 Automatic motor data identification
Via the motor parameter identification, the inverter characteristic, the influences of the motor
cable, and the motor parameters listed in the table below can be identified automatically:
Automatic calculation of the current controller and field controller parameters
From version 12.00.00 onwards: Following successful motor parameter identification, the current
controller and field controller parameters listed in the below table are calculated as well.
• If these parameters are not to be calculated, bit 4 of C02865/1 must be set to "1".
Automatic calculation of the speed controller parameters
From version 12.00.00 onwards: Following successful motor parameter identification, the speed
controller parameters listed in the below table can also be calculated automatically.
• If these parameters are to be calculated, bit 6 of C02865/1 must be set to "5".
Parameter Info ASM PSM
C00015 V/f base frequency  
C00016 V
min
boost  
C00021 Slip compensation 
C00082 Motor rotor resistance 
C00083 Motor rotor time constant 
C00084 Motor stator resistance  
C00085 Motor stator leakage inductance  
C00092 Motor magnetising inductance 
C00095 Motor magnetising current 
Parameter Info ASM PSM
C00073/1 VFC: Vp Imax controller  
C00075 Vp current controller  
C00076 Ti current controller  
C00077 SC: Vp field controller 
C00078 SC: Tn field controller 
Parameter Info ASM PSM
C00070/1 SLVC: Vp speed controller 
C00071/1 SLVC: Ti speed controller 
C00070/2 SC: Vp speed controller  
C00071/2 SC: Ti speed controller  
C00072 SC: Tdn speed controller  
C00070/3 SLPSM: Vp speed controller  
C00071/3 SLPSM: Ti speed controller  