3 commissioning, Commissioning, 3commissioning – Lenze 8400 User Manual
Page 48
3
Commissioning
48
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3
Commissioning
Tip!
• Information on some of the operating statuses can quickly be obtained via the
on the front of the controller.
• Check firmware: Particularly with regard to the use of older controllers (e.g. if the
customer is using one from stock) it makes sense to check the software (firmware)
version. The software version of the controller can be seen on the nameplate in the "SW"
line and can be determined by reading out code
• Restore delivery status: Set code
to "1: On / start" to reset all parameter
settings of the device to the Lenze setting. This leaves you with a defined device
configuration.
Danger!
Uncontrolled motor movements can occur
Under certain conditions the motor may rotate after mains connection.
Possible consequences:
• Persons in the vicinity of the machine or plant risk getting hurt.
• Unexpected starting action may damage the machine or plant.
Protective measures:
• Commissioning with external 24 V supply and without mains voltage. In this case, the
controller can only be parameterised and diagnosed during commissioning.
• Remove the motor plug X21. An active motor temperature monitoring prevents the
output of a motor voltage. If monitoring is deactivated, a voltage can be applied to the
plug.
• Ensure that setpoints are not active.
The following chapters describe the commissioning of the available technology
applications with the »Engineer«.
Information on the commissioning with the keypad (diagnosis terminal) is provided in
the 8400 protec hardware manual.
• The hardware manual has been stored in electronic form on the data carrier supplied
with the 8400 drive controller.