Lenze 8400 - Manual (Page 1003)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
1003
16 Parameter reference
16.2 Parameter list | C01232
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01232
C01233
C01234
Parameter | Name:
C01232 | MCK: Manual jog accelerations
Data type: INTEGER_32
Index: 23343
d
= 5B2F
h
Acceleration/deceleration for manual jog
 Manual jog
Setting range (min. value | unit | max. value)
-214748.3647 units/s2 214748.3647
Subcodes Lenze setting Info
C01232/1 720.0000 units/s2 Manual jog: Acceleration
• Acceleration for ramp-up to manual speed.
C01232/2 720.0000 units/s2 Manual jog: Deceleration
• Deceleration for manual speed ramp-down to
standstill.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01233 | MCK: Manual jog S-ramp time
Data type: UNSIGNED_16
Index: 23342
d
= 5B2E
h
S-ramp time for manual jog
• Setting "0 s" ≡ no rounding
 Manual jog
Setting range (min. value | unit | max. value)
0.000 s 10.000
Subcodes Lenze setting Info
C01233/1 0.000 s Manual jog: S-ramp time
• S-ramp time for the manual speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01234 | MCK: Manual jog breakpoints
Data type: INTEGER_32
Index: 23341
d
= 5B2D
h
Breakpoint positions for manual jog
• The drive stops at the parameterised positions if these are located in the manual jog direction and the
approaching of the breakpoints is switched on in C01230 via bit 0.
 Manual jog
Setting range (min. value | unit | max. value)
-214748.3647 unit 214748.3647
Subcodes Lenze setting Info
C01234/1 0.0000 unit Manual jog: Breakpoint 1
C01234/2 0.0000 unit Manual jog: Breakpoint 2
C01234/3 0.0000 unit Manual jog: Breakpoint 3
C01234/4 0.0000 unit Manual jog: Breakpoint 4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000