Lenze 8400 - Manual (Page 37)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
37
2 Introduction: Parameterising the controller
2.3 General notes on parameters
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.2 Change parameter settings with PC and Lenze software
The USB diagnostic adapter, for instance, can be used for the communication between the PC
(including the L-force »EASY Starter« or L-force »Engineer« software) and the controller (see the
following illustration). The USB diagnostic adapter is the connection between the PC (free USB port)
and the controller (diagnostic interface X70).
[2-3] Exemplary constellation for parameterising the controller
The All parameters tab in the »EASY Starter« and the »Engineer« provides a quick access to all
parameters of the controller.
The given categories and subcategories correspond 1:1 to the menus and submenus of the keypad:
[2-4] All parameters tab in the »Engineer«
Moreover, the »Engineer« provides a commissioning interface on the Application parameters tab
where you can commission the application in a few steps.
 Category
 Subcategories

Detailed information on how to handle the »Engineer« can be found in the integrated
online help that you can call with the [F1] function key.