Lenze 8400 - Manual (Page 563)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
563
9 Diagnostics & error management
9.5 Drive diagnostics via keypad/bus system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.5 Drive diagnostics via keypad/bus system
Keypad display of the controller status
• If the diagnosis terminal is connected to the diagnostic
interface X70, the status of the controller is shown via
different icons on the LCD display in the area .
Icon Meaning Note

Controller is switched on.  SwitchedOn ( 114)

Controller is enabled.

Application in the controller is stopped.

Quick stop active

Controller is inhibited. The power outputs are inhibited.

Controller is ready to start.  ReadyToSwitchOn ( 113)

Speed controller 1 at the limit. The drive is torque-controlled.

Set current limit has been exceeded in motor
or generator mode.

Pulse inhibit active The power outputs are inhibited.

System fault active

Fault  Fault ( 118)

Trouble  Trouble ( 117)

TroubleQSP  TroubleQSP ( 116)

Warning active