Lenze 8400 - Manual (Page 1152)

17 Working with the FB Editor
17.8 Copying an interconnection
1152
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
17.8 Copying an interconnection
In contrast to copying/inserting selected interconnection elements via the clipboard, the function
described in this chapter serves to replace the current FB interconnection of a device completely by
the FB interconnection of another project device.
A complete interconnection comprises:
• Function blocks (use and parameter values)
• System blocks (application and parameter values)
• Port blocks (use and parameter values)
• Connections
• Comments
• Interconnection layout (arrangement of the modules)
• Port definition of the ports used in the FB interconnection

How to copy the complete interconnection into another project device:
1. Select the application with the FB interconnection to be copied in the project view.
2. Select the command Application dataCopy FB interconnections....
3. Go to project view and select the application which is to be inserted into the copied FB
interconnection.
4. Select the command Application dataAdd FB interconnection....
• The command can only be activated if an FB interconnection has been copied from a
device of the same device type and version.
• After the command has been executed, the module assembly is compared. If there are
relevant deviations, the insertion is refused and a corresponding message is displayed.
• If an insertion is possible, you are asked if the FB interconnection is to be inserted.
5. Confirm the question if the copied FB interconnection is to be inserted with Yes.
• After the insertion, an update of the project is required.

Note!
The complete FB interconnection can only be copied between devices of the same device
type and version (e.g. 8400 HighLine C V1.0).