Lenze 8400 - Manual (Page 1052)

16 Parameter reference
16.2 Parameter list | C02314
1052
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02314
C02580
Parameter | Name:
C02314 | Sensibility - Setpoint feedforward control
Data type: UNSIGNED_8
Index: 22261
d
= 56F5
h
From version 12.00.00 onwards : Parameter values (1st value ... 4th value) for optional motor data change-over
Selection list
0 Inactive
1 15 bits
2 14 bits
3 13 bits
4 12 bits
5 11 Bit
6 10 Bit
7 9 Bit
Subcodes Lenze setting Info
C02314/1 0: Inactive Sensibility - Setpoint feedforward control
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C02580 | Holding brake: Operating mode
Data type: UNSIGNED_8
Index: 21995
d
= 55EB
h
Selection of the operating mode for holding brake control
 Holding brake control
Selection list (Lenze setting printed in bold) Info
0 Brake control off No holding brake is used. Internal control is switched off.
11 Manually controlled The holding brake is released and closed via a control bit
in the MCK control word.
12 Autom. controlled The holding brake is automatically released and closed
via speed setpoint comparisons.
13 Semi-automat. controlled From version 06.00.00
The holding brake is released and closed via a control bit
in the MCK control word.
• In contrast to the manual operation (mode 11)
• the feedforward control is active in this mode,
preventing a sagging e.g. in case of a hoist.
• the brake in this mode also closes when the
controller is inhibited in order to prevent the axis in
a hoist from falling.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1