Lenze 8400 - Manual (Page 1251)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
1251
18 Function library
18.1 Function blocks | L_Curve_3
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Tensile force profile according to characteristic
The characteristic () can be parameterised in
C01033/1...32 .
• The characteristic comprises 32 values, regularly distributed over the diameter range of
D0 ... DMax.
• The values are to be set as raw values (±16384 ≡ ±100 %).
• nD0_a serves to define the start of the table range (D0).
• nCurveCtrl_a serves to change the slope of the characteristic.
• When nCurveCtrl_a = 0 %, the slope of the characteristic remains unchanged.
Tensile force profile according to defined characteristic ( C01035/3 = 6)
Characteristic

Tensile force
 Diameter
Function for D > D0:
 Table function (e.g. line)
TAB[D-
D0]
Table value [1...32]for D-D0
D0 Initial point for diameter dependency (nD0_a)
HW Tensile force valuation (nCurveCtrl_a)
Œ

DMin
(DMax)
D0 100 %
100 %
0 %
100 %
nCurveCtrl_a = 0 %
HW
TAB[1]
TAB[32]
0
100 %
100 % TAB[D-D0] – ( ) 100 % HW – ( ) ⋅
100 %
----------------------------------------------------------------------------------------------- –