Lenze 8400 - Manual (Page 744)

16 Parameter reference
16.2 Parameter list | C00008
744
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Terminal assignment of the control modes 10 ... 16
C00008
"Actuating drive speed" TA
Input/output 10: Terminals 0 12: Terminals 2 14: Terminals 11 16: Terminals 16
RFR Controller enable / Reset of error message
DI1 Fixed setpoint 1/3 Change of direction of
rotation
Fixed setpoint 1/3
DI2 Fixed setpoint 2/3 Activate manual DC-
injection braking (DCB)
Fixed setpoint 2/3
DI3 Activate manual DC-injection
braking (DCB)
Quick stop Motor potentiometer:
Increase speed
CW rotation quick stop
DI4 Change of direction of rotation Motor potentiometer:
Decrease speed
CCW rotation quick stop
DI5 - - - -
DI6 - - - -
A1U Main speed setpoint (10 V ≡ 100 % reference speed)
TA "Table positioning"
Input/output 10: Terminals 0 12: Terminals 2 14: Terminals 11 16: Terminals 16
RFR Controller enable / Reset of error message
DI1 - - Positive limit switch -
DI2 - - Negative limit switch -
DI3 Positive limit switch - - -
DI4 Negative limit switch Positioning profile, array bit (valency 2) Quick stop
DI5 Positioning profile,
array bit (valency 2)
Positioning profile, array bit (valency 1) Positioning profile,
array bit (valency 2)
DI6 Start of profile generation
A1U Main speed setpoint (10 V ≡ 100 % reference speed)
"Switch-off positioning" TA
Input/output 10: Terminals 0 12: Terminals 2 14: Terminals 11 16: Terminals 16
RFR Controller enable Controller enable / Reset of error message
DI1 Fixed setpoint 1/3 Stop function 1 Fixed setpoint 1/3
DI2 Fixed setpoint 2/3 Stop function 2 Selection: Pre-switch off 1 Fixed setpoint 2/3
DI3 Reset error message CW rotation quick stop
Selection: Switch-off position 1
CW rotation quick stop
DI4 Change of direction of
rotation
CCW rotation quick stop
Selection: Switch-off position 2
CCW rotation quick stop
DI5 - - Stop function 2 -
DI6 - - Selection: Pre-switch off 2 -
A1U Main speed setpoint (10 V ≡ 100 % reference speed)
Parameter | Name:
C00008 | Original application|control source
Data type: UNSIGNED_16
Index: 24567
d
= 5FF7
h
Display of the originally selected technology application and the originally selected control mode.
• This parameter shows the selection that was set with C00005 and C00007 before a change in the I/O level or the
application level was carried out.
• For diagnostic purposes, this display serves to determine whether there is a standard interconnection in the
controller or a change carried out by the user.
Selection list (read only) Info
0 Free|Free Application: Interconnection has been changed.
I/O level: Interconnection has been changed.
10 Free|Terminal0 Application: Interconnection has been changed.
I/O level: "Terminals 0" control mode