Lenze 8400 - Manual (Page 376)

7 Technology applications
7.3 TA "Table positioning"
376
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.3.1 Basic signal flow
The main element of the technology application is the Motion Control Kernel.
• The Motion Control Kernel is controlled via a 32-bit double control word. All motion profiles in
the different operating modes can be controlled with this interface.
• Upstream to the Motion Control Kernel there is a so-called MCKInterface called which provides
additional process inputs for the application in order to control the Motion Control Kernel.
[7-6] Signal flow of the table positioning
7.3.1.1 Possibilities for the position selection
The following options are available for the selection of different positions:
 Offset and gain ( L_OffsetGainP_1 )  MCK control word
 Motor potentiometer function ( L_MPot_1 )  MCK status word
 Setpoint generator ( L_NSet_1 )  Selection of the machine parameters
 Offset and gain ( L_OffsetGainP_2 )  Profile entry for the "Positioning" basic function.
 Speed setpoint input limitation  Holding brake control
 Basic function " Homing "  MCKInterface
 Basic function " Manual jog "  Status word of the MCKInterface
 Operating mode changeover
(is executed by the MCKInterface )
 Terminal assignment & display
of digital control signals
 Integrated disposable "GeneralPurpose" functions : Analog switch, arithmetic, multiplication/division, binary
delay element, binary logic, analog comparison, D-flipflop