Lenze 8400 - Manual (Page 740)

16 Parameter reference
16.2 Parameter list
740
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00002/26 0: Off / ready CAN reset node
• Reinitialise CAN interface
• Required when changing the baud rate, node address,
or identifiers.
 CANopen Option/CAN on board
C00002/27 0: Off / ready Device search function
• From version 06.00.00
• This device command serves to optically locate a
controller connected online (e.g. for maintenance
work).
 Device search function
C00002/28 0: Off / ready Check MasterPin
• From version 06.00.00
 Unlocking the controller with a MasterPin
C00002/29 0: Off / ready Set binding ID
• From version 06.00.00
 Device personalisation
C00002/30 0: Off / ready Delete binding ID
• From version 06.00.00
 Device personalisation
C00002/31 0: Off / ready Set password
• From version 06.00.00
 Password protection
C00002/32 0: Off / ready Check password
• From version 06.00.00
 Password protection
C00002/33 0: Off / ready Delete password
• From version 06.00.00
 Password protection
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00002 | Device command
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h