Lenze E94AxPExxxx - Manual (Page 854)

15 Parameter reference
15.2 Parameter list | C00995
854
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00995
C00998
C01120
Parameter | Name:
C00995 | Flying restart: Delay time
Data type: UNSIGNED_32
Index: 23580
d
= 5C1C
h
 Flying restart function
Setting range (min. value | unit | max. value) Lenze setting
0 ms 10000 0 ms
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00998 | VFC: Frequency setpoint
Data type: INTEGER_32
Index: 23577
d
= 5C19
h
 V/f control
Display range (min. value | unit | max. value)
-800.0 Hz 800.0
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C01120 | Sync source
Data type: UNSIGNED_8
Index: 23455
d
= 5B9F
h
Selection of the source for the synchronisation signals.
• The drive can only be synchronised by one source.
Note:
Set the selection "2: CAN module" for the communication module CANopen (E94AYCCA).
 "CAN on board" system bus: sync telegram
Selection list (Lenze setting printed in bold)
0 Off
1 CAN on board
2 CAN module
4 Module in MXI1
5 Module in MXI2
6 Digital input 1
7 Digital input 2
8 Digital input 3
9 Digital input 4
10 Digital input 5
11 Digital input 6
12 Digital input 7
13 Digital input 8
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1