Lenze E94AxPExxxx - Manual (Page 810)

15 Parameter reference
15.2 Parameter list | C00413
810
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00413
C00414
C00415
C00416
C00417
Parameter | Name:
C00413 | Hiperface: detected TypeCode
Data type: UNSIGNED_32
Index: 24162
d
= 5E62
h
Type code read out of the connected Hiperface encoder
 Parameterisation of an unknown Hiperface encoder
Display range (min. value | unit | max. value)
0 255
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00414 | Hiperface: TypeCode
Data type: UNSIGNED_32
Index: 24161
d
= 5E61
h
Setting the type code for a Hiperface encoder unknown to the controller
 Parameterisation of an unknown Hiperface encoder
Setting range (min. value | unit | max. value) Lenze setting
0 255 0
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00415 | Hiperface: number of rev.
Data type: UNSIGNED_32
Index: 24160
d
= 5E60
h
Number of displayable revolutions for a multi-turn encoder
 Parameterisation of an unknown Hiperface encoder
Setting range
(min. value | unit | max. value)
Lenze setting
0 16384 0
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00416 | Service code
Data type: UNSIGNED_32
Index: 24159
d
= 5E5F
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00417 | Dynamic of resolver evaluation
Data type: UNSIGNED_32
Index: 24158
d
= 5E5E
h
From software version V2.0
 Adaptation of the resolver evaluation dynamics
Setting range (min. value | unit | max. value) Lenze setting
100 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1