Lenze E94AxPExxxx - Manual (Page 832)

15 Parameter reference
15.2 Parameter list | C00641
832
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00641
C00642
C00643
C00644
Parameter | Name:
C00641 | PLI 360° current amplitude
Data type: UNSIGNED_32
Index: 23934
d
= 5D7E
h
Percentage adjustment of the current amplitude for the pole position identification
Stop!
If there is no temperature monitoring in the motor and/or the I2xt motor monitoring is not parameterised correctly,
the motor may be permanently damaged when the current amplitude is set too high (e.g. to the maximum value)!
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
1 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00642 | PolePosId 360° ramp time
Data type: UNSIGNED_32
Index: 23933
d
= 5D7D
h
Percentage adjustment of the ramp time for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
5 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00643 | PLI 360° traversing direction
Data type: UNSIGNED_32
Index: 23932
d
= 5D7C
h
Selection of the traversing direction for the pole position identification
 Adjustment of the pole position identification
Selection list (Lenze setting printed in bold)
0 Right rotating field
1 Left rotating field
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00644 | PolePosId 360° fault tol.
Data type: INTEGER_32
Index: 23931
d
= 5D7B
h
Fault tolerance for the plausibility check of the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
-6.0 ° 30.0 0.0 °
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10