Lenze E94AxPExxxx - Manual (Page 736)

14 Diagnostics & fault analysis
14.7 Error messages of the operating system
736
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Cam data locked due to incorrect password [0x00b80016]
Cam data locked due to incorrect safety key [0x00b80017]
Homing mode not allowed [0x00b80019]
Cam data: Invalidated due to change of mechanical data [0x00b80034]
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 22
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The cam data were locked since the user password was
entered incorrectly for three times.
The cam data were not loaded.
Reset parameters to the Lenze setting via device
command C00002 = "0: Load Lenze setting". Then
download cam data again.
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 23
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The cam data were not loaded because the safety key is
damaged.
The password in the cam data or the serial number of the
memory module has been manipulated.
Reset parameters to the Lenze setting via device
command C00002 = "0: Load Lenze setting". Then
download cam data again.
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 25
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The homing mode selected in C02640 is not supported in
the motor control type selected in C00006 .
Select another homing mode in C02640 .
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 52
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
One or several machine parameters which have an
influence on the internal scaling of the cam data have
been changed. The cam data have to be recalculated.
Execute device command C00002 = "503: Calculate Cam
Data". This automatically resets the warning.