Lenze E94AxPExxxx - Manual (Page 674)

14 Diagnostics & fault analysis
14.7 Error messages of the operating system
674
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Controller enabled [0x00750001]
Controller in STO state [0x00750003]
Controller: Pulse inhibit is active [0x00750005]
PLC configuration invalid [0x00750006]
Heatsink: Temperature > C00122 [0x00770000]
Module ID (decimal) Error ID (decimal)
117: Device control 1
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The controller is enabled and has the "Operation" state. - (Information only)
Module ID (decimal) Error ID (decimal)
117: Device control 3
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The controller has received the "Safe torque off (STO)"
request by the safety module and is now in the "Safe
torque off active" device state.
- (Information only)
Module ID (decimal) Error ID (decimal)
117: Device control 5
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The pulse inhibit is active in the controller. - (Information only)
Module ID (decimal) Error ID (decimal)
117: Device control 6
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An invalid control configuration has occurred. Load a different application.
Module ID (decimal) Error ID (decimal)
119: Temperature monitoring 0
Response (Lenze setting printed in bold) Setting: C00582 ( Adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Heatsink temperature higher than variable temperature
limit ( C00122 ).
• Ambient controller temperature too high.
• Dirty fan or ventilation slots.
• Value set under C00122 is too low.
• Check control cabinet temperature.
• Clean filter.
• Clean controller.
• Set a higher value in C00122 .