Lenze E94AxPExxxx - Manual (Page 646)

14 Diagnostics & fault analysis
14.7 Error messages of the operating system
646
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.7.2 Reset error message
An error message with the response "Fault", "Quick stop by trouble", or "Warning locked" must be
reset (acknowledged) explicitly after the cause of error has been eliminated.

To reset (acknowledge) a pending error message, execute the device command
C00002 = "43: Reset error".

Tip!
When an online connection to the controller has been established, use the Diagnostics tab
of »Engineer« and click Reset error to reset a pending error message.