Lenze E94AxPExxxx - Manual (Page 772)

15 Parameter reference
15.2 Parameter list | C00142
772
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00142
C00150
Parameter | Name:
C00142 | Autom. restart after mains ON
Data type: UNSIGNED_32
Index: 24433
d
= 5F71
h
Starting performance of the controller after mains connection and reset of "Trouble", "Fault" or "Safe torque off
active".
 Danger!
• If automatic restart is enabled ( C00142 = "1: Enabled"), the drive can restart automatically from the "Trouble"
and "Safe torque off" device states when the trouble or request for "Safe torque off active" has been eliminated!
• The controller enable generated by the application via a connection of the terminal 28 (RFR) with one of the
digital outputs DIGOUT_bOut(x) is not permissible if the following functions are active:
"Auto-start after mains ON" ( C00142 = "1") and "Program auto-start after mains switching" ( C02104 = "1")
If this is not observed, the controller can start automatically after mains connection!
 Automatic restart after mains connection
 Activate application
Selection list (Lenze setting printed in bold)
0 Inhibited
1 Enabled
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00150 | Status word device control 1
Data type: BITFIELD_16
Index: 24425
d
= 5F69
h
Status word 1 of the drive interface
Display area
0x0000
0xFFFF
Value is bit-coded: Info
Bit 0 Reserved For the meaning of bits 8 ... 11 see chapter " Device
states ".
Bit 1 Pulse inhibit active
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Actual speed value = 0
Bit 7 Controller inhibit active
Bit 8 Device state - Bit 1
Bit 9 Device state - Bit 2
Bit 10 Device state - Bit 3
Bit 11 Device state - Bit 4
Bit 12 Warning is active
Bit 13 Trouble is active
Bit 14 Reserved
Bit 15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1