Lenze E94AxPExxxx - Manual (Page 796)

15 Parameter reference
15.2 Parameter list | C00350
796
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00350
C00351
C00352
Parameter | Name:
C00350 | CAN node address
Data type: UNSIGNED_8
Index: 24225
d
= 5EA1
h
• A change in the node address will not be effective until a CAN Reset Node is performed.
• The basic server channel RX/TX is automatically provided by the node address ( C00372 and C00373 ; subcode 1).
• Overwriting the value deactivates a possibly existing node address selection entered by means of hardware.
 "CAN on board" system bus
Setting range (min. value | unit | max. value) Lenze setting
1 127 1
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00351 | CAN baud rate
Data type: UNSIGNED_8
Index: 24224
d
= 5EA0
h
• A change in the baud rate will not be effective until a CAN Reset Node is performed.
• Overwriting the value deactivates a possibly existing node address selection entered by means of hardware.
 "CAN on board" system bus
Selection list (Lenze setting printed in bold)
0 500 kbps
1 250 kbps
2 125 kbps
3 50 kbps
4 1 Mbps
5 20 kbps
6 10 kbps
8 Reserved
9 Reserved
10 Reserved
11 Reserved
12 Reserved
13 Reserved
14 800 kbps
15 Reserved
255 Automatic recognition
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00352 | CAN slave/master
Data type: UNSIGNED_8
Index: 24223
d
= 5E9F
h
The drive starts as CAN master after mains switching if a value of "1" has been entered and saved here.
 "CAN on board" system bus
Selection list (Lenze setting printed in bold)
0 Slave
1 Master
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1