Lenze E94AxPExxxx - Manual (Page 112)

5 Drive interface
5.2 Device commands
112
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.2.17 Reset error
The C00002 = "43: Reset error" device command is used to acknowledge an error message if the
error cause has been eliminated and the error is thus no longer pending.

Tip!
An error message can also be acknowledged by activating the Reset error button in the
Diagnostics tab.
Further information on error messages can be found in the chapter "
Diagnostics & fault
analysis ". ( 630)

Note!
This device command has no status display in C00003 , i.e. the display remains
unchanged showing the previous device command status.