1 possibilities for the selection of the profile, Possibilities for the selection of the profile, 12 basic drive functions – Lenze E94AxPExxxx User Manual
Page 514
12
Basic drive functions
12.7
Positioning
514
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.7.1.1
Possibilities for the selection of the profile
For specifying as well as storing and managing (travel) profiles, the following function blocks are
available:
Related topics:
Function block
Function
L_PosPositionerTable
...serves to store and manage up to 100 (travel) profiles and to "Teach"
positions, speeds, accelerations/decelerations and S-ramp times.
• A further important task of this FB is the conversion of the table values
according to the preselected scaling in the LS_DriveInterface SB.
L_PosProfileTable
...serves to store and manage up to four (travel) profiles and allows the
"teaching" of target positions.
• In contrast to the FB L_PosPositionerTable this FB does not use any
variable tables but the data of the profile parameters are entered directly
into the assigned codes.
• The position at the input dnExtPos_p is used as target position as a
further specific feature for the selection of profile no. 1.
L_PosProfileInterface
...provides a profile data set for the LS_Positioner SB.