Lenze E94AxPExxxx - Manual (Page 236)

6 Motor interface
6.6 V/f control (VFCplus)
236
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.6.2 Optimising the control mode
The "optimisation steps" given in the following table serve to further optimise the control behaviour
of the V/f control and adjust it to the concrete application.
• Detailed information on the individual steps can be found in the following subchapters.
Optimisation steps
1. Defining a user-defined V/f characteristic . ( 237)
• Individual adjustment of the motor magnetisation to the concrete application if linear and square-law
characteristics are not suitable.
2. Parameterising slip compensation . ( 238)
3. Parameterising oscillation damping . ( 239)
4. When the flying restart function is used: Optimise flying restart process.  Flying restart function ( 257)
5. Optimise current controller . ( 241)
• Only required if one of the following functions is used:
• Voltage vector control ( 234)
• Flying restart function ( 257)
• DC-injection braking ( 260)
6. Save »Engineer« project.