Lenze E94AxPExxxx - Manual (Page 715)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
715
14 Diagnostics & fault analysis
14.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Position value faulty [0x00910010]
Error during initialisation [0x00910011]
Block function in wrong MEC task [0x00910012]
Safety module: Incompatible with setting in C00214 [0x00920000]
Communication with safety module interrupted [0x00920001]
Module ID (decimal) Error ID (decimal)
145: Lenze runtime system 16
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Module ID (decimal) Error ID (decimal)
145: Lenze runtime system 17
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Module ID (decimal) Error ID (decimal)
145: Lenze runtime system 18
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Module ID (decimal) Error ID (decimal)
146: Interface to the safety module 0
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The controller has detected a safety module which does
not match the setting under C00214 .
Change setting under C00214 or use a suitable safety
module.
• Afterwards mains switching is required.
Module ID (decimal) Error ID (decimal)
146: Interface to the safety module 1
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
It is not possible to establish communication between
the controller and safety module.
• Switch off the controller, plug in safety module
correctly and switch on the controller again.
• If the problem occurs again, replace the safety
module.