Table 4 – H3C Technologies H3C Intelligent Management Center User Manual
Page 88
66
Table 4 Security information parameters
Encryption Security information parameters
None
No security parameters need to be configured.
Static WEP
•
Key Length—Select the key length. Options are 64 bits and 128 bits.
•
Key Type—Select the key type. Options are ASCII and HEX.
•
Key Index—Select the key index. Options are 1, 2, 3, and 4.
•
Key—Enter the value of the key. Valid value range is determined by Key Length and
Key Type. For more information, see
.
Dynamic WEP
•
Address (Primary Authentication Server)—Enter the IP address or domain name of
the primary authentication server.
•
Port—Enter the port used by the authentication server to listen for authentication
packets.
•
Secret—Enter the password used for communication between the AC and the
authentication server.
•
Retry Interval (s)—Specify the time the AC must wait before retrying to communicate
with the authentication server after a communication times out.
•
Retry Timeout (s)—Click the box next to the Retry Timeout (s) field to enable the
server response timeout timer and specify the server response timeout time. If an AC
sends an authentication request to the authentication server, but receives no
response in the specified time, it considers the authentication request timed out. If
you do not enable this feature, AC determines whether an authentication request has
timed out according to the default timeout value configured on the RADIUS server.
•
Secondary RADIUS Server—Click the box next to the Secondary RADIUS Server field
to enable the secondary authentication server.
•
Address—Enter the IP address or domain name of the secondary authentication
server. This field appears only when Secondary RADIUS Server is enabled.
•
Secret—Enter the password used for communication between the AC and the
secondary authentication server. This field appears only when Secondary RADIUS
Server is enabled.
WPA Pre-Shared
Key
•
Version—Select a WPA version. Options are WPA, WPA2, and WPA or WPA2. The
default cipher value varies with the WPA version. For more information, see
.
•
Cipher—Select a link layer encryption protocol. Options are TKIP, CCMP (AES), and
TKIP+CCMP (AES). The parameter is determined by Encryption and Version.
•
Key Type—Key type defaults to ASCII, which cannot be modified.
•
Pre-Shared Key—Enter the pre-shared key.