H3C Technologies H3C Intelligent Management Center User Manual
Page 177
155
NOTE:
To avoid configuration failures, configure a profile name and SSID different from those of an
existing WLAN on the AC.
{
Admin Status—Select Enable. A WLAN is enabled immediately after it is created. Because
the WLAN is automatically assigned to the default group, all APs in the default group use
this WLAN to provide wireless services.
{
Broadcast SSID—Indicates whether the Beacon frames sent by an AP carries this SSID. Select
Enable or Disable. If Disable is selected, clients cannot detect this SSID.
6.
Configure a security policy in the Security Information area:
{
Encryption—Select an encryption method for the WLAN. Options are:
−
None
−
WPA+WPA2
−
802.1X
−
Static WEP
−
Static WEP+802.1X
−
CKIP
For more information about the security policy, see
.
7.
In the Selected Devices area, select the ACs where you want to create WLANs.
{
All ACs—Select this option to create WLANs on all Cisco ACs.
{
Selected ACs—Select this option to create WLANs on the selected ACs.
a.
Select Selected ACs from the Selected Devices list.
b.
Click Add in the AC List area. A dialog box for selecting devices appears.
c.
Enter or select one or more of the following query criteria in the Query area:
−
Device Label—Enter the device label of the AC. WSM supports fuzzy matching for this
field.
−
IP Address—Enter the IP address of the AC. WSM supports fuzzy matching for this field.
−
Model—Select the model of the AC. Options are models of all Cisco ACs on the AC List.
d.
Click Query. The Device List displays all ACs matching the query criteria. Click Reset to
clear the query criteria and display all ACs.
e.
Select one or multiple ACs in the Device List area and click OK.
The AC List displays the selected ACs.
8.
Click the Delete icon to delete the target AC.
9.
Click OK.
The Result List page appears, displaying the operation result for creating WLANs on each AC.
Result List
{
Device Label—Label of the AC.
{
SSID—SSID of the WLAN.
{
Profile Name—Profile name of the WLAN.
{
Result—Operation result for creating WLANs. If the operation fails, WSM provides the cause
of failure. You can modify the configuration to create WLANs again.
10.
Click Back to go back to the Batch Create WLANs page.