H3C Technologies H3C Intelligent Management Center - Manual (Page 661)

639
No specific parameters are required for viewing a rogue AP report.
Figure 99 shows an example rogue AP report.
Figure 99 Rogue AP report
Rogue AP report fields:
• MAC Address—MAC address of the rogue AP.
• Vendor—Vendor of the rogue AP.
• SSID—SSID of the rogue AP.
• Max Signal Strength—Maximum signal strength of the rogue AP.
• Channel—Channel used by the rogue AP.
• Detected by—AC that detected the rogue AP.
• Last Discovered Time—Time when the rogue AP was last discovered.
• Attacked Status—State of the rogue AP, Attacked or Not Attacked.
Rogue client history report
This report displays the history records of detected rogue clients by MAC address.
To view a rogue client history report, configure the following parameters:
• Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or
select Custom Range, and then specify the start time and end time manually.