H3C Technologies H3C Intelligent Management Center - Manual (Page 722)

700
6. Configure the basic information..
{
Enter the AP model and vendor.
{
Click Browse… to select a picture for the X-share antenna.
7. Click OK.
The page for displaying the AP model details appears.
8. In the Radio List area, click Add.
The Add Radio dialog box appears.
9. Enter or select one or more of the following query criteria to search for the radios you want to
add from the Add Radio dialog box:
{
Radio ID—Enter the radio ID, ranging from 1 to 9.
{
Radio Type—Select the radio type. Options are:
− 802.11a
− 802.11b
− 802.11g
− 802.11an
− 802.11gn
{
Default Transmission Power (dBm)—Enter the default transmission power of the radio, in the
range of 1 to 30.
{
Antenna—Select the antenna type for the radio.
{
Bandwidth Mode—Select the bandwidth of the radio signals. Options are 20MHz and
40MHz. This field is available only when the Radio Type is 802.11an or 802.11gn.
{
A-MPDU—Set whether to enable the A-MPDU on the interface. This field is available only
when the Radio Type is set to 802.11an or 802.11gn.
{
A-MSDU—Set whether to enable the A-MSDU on the interface. This field is available only
when the Radio Type is set to 802.11an or 802.11gn.
{
Short GI—Set whether to enable the short GI. The short GI protects data from interference
due to delay. This field is available only when the Radio Type is set to 802.11an or 802.11gn.
10. Click OK.
The radio is added to the AP model.
11. Click Back to go back to the AP Model Management page.
The AP model is added to the AP Model List.
Modifying an AP model
This function helps you modify the existing AP models. For a system-defined AP model, you can only
modify the radio parameters. For a user-defined AP model, you can modify the model, vendor, and
radio parameters of the AP model.
To modify an AP model:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Configuration Management.
The Configuration Management page appears.
3. Click the Common tab.