H3C Technologies H3C Intelligent Management Center - Manual (Page 125)

103
Normal method
To add a service policy by using the normal method:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
The AC List page displays all ACs.
3. Click the Operation icon for the target AC.
4. Select Service Policy from the menu.
The Service Policy Management page appears. All the service policy information of the AC is
displayed on the Service Policy List.
5. Click Add Policy. The page for adding a service policy appears.
6. Set the following parameters as needed:
{
Policy ID—Enter an ID of the service policy to uniquely identify the service policy on the AC.
{
Enable—Select this option if you want to enable the service policy immediately after it is
applied to the AC. Otherwise, do not select this option.
{
SSID—Enter the SSID of the service policy, which must be unique.
{
Encryption Mode—Select the encryption mode for the service policy. Options are:
− Clear—No data packets need to be encrypted.
− Crypto—All data packets need to be encrypted.
{
Hide SSID—Select this option to hide the SSID in beacon frames sent by the fit AP. When this
parameter is selected, clients cannot obtain the SSID from the beacon frames and must
configure the SSID before accessing the wireless network. If this parameter is not selected,
clients can obtain the SSID from the beacon frames.
{
Authentication Mode—Authentication mode of the service policy. Options are:
− Open System—Allows all clients requesting for authentication to directly pass
authentication.
− Shared Key—Requires clients to use the same shared key as that configured on the
device. Specify Shared Key only when you select WEP40 or WEP104 as the cipher suite.
− All—Allows clients to use either the Open System mode or the Shared Key mode as
needed.
When the encryption mode is Clear, the authentication mode can only be Open System.
When the encryption mode is Crypto, the authentication mode options are Open System,
Shared Key, and All.
{
Binding Interface—This parameter is forcibly selected and requires you to bind a WLAN
logical interface to the service policy to be added.
{
Interface ID—Enter the interface ID to be bound to the service policy. If the ID represents a
non-existent WLAN logical interface, WSM automatically creates the WLAN logical
interface for the AC. Make sure the WLAN logical interface is not bound to any other
service policy. Otherwise, the service policy configuration fails.
{
Interface Type—Select the type of the interface to be bound to the service policy, which is
always WLAN-ESS.
{
Max Clients—Maximum number of clients that can use the service policy to associate with fit
APs.