H3C Technologies H3C Intelligent Management Center - Manual (Page 137)

115
4. Click the Load Balance Group link in the AC Configuration area to the right of the page. All the
load balancing group information of the AC is displayed in the Load Balance Group List.
5. Click the Delete icon for the load balancing group you want to delete.
A confirmation dialog box appears.
6. Click OK.
Viewing radios in a load balancing group
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs. The AC List
page displays all ACs.
3. Click the device label of the target AC.
4. Click the Load Balance Group link in the AC Configuration area to the right of the page. All the
load balancing group information of the AC is displayed in the Load Balance Group List.
5. Click the ID of the target load balancing group.
The Radio List page appears.
Radio List contents
{
AP Label—Label of the fit AP to which the radio belongs.
{
SN—Serial number of the fit AP to which the radio belongs.
{
Radio ID—ID of the radio.
{
Radio Type—Radio type: 802.11a, 802.11b, 802.11g, 802.11gn, or 802.11an.
{
Delete—Click the Delete icon to delete the radio.
If the Radio List contains enough entries, the following navigational aids are displayed.
Navigating the Radio List
• Click the Next Page icon to page forward in the Radio List.
• Click the Last Page icon to page forward to the end of the Radio List.
• Click the Previous Page icon to page backward in the Radio List.
• Click the First Page icon to page backward to the front of the Radio List.
Click 8, 15, 50, 100, or 200 at the upper right of the Radio List to configure the number of items per
page you want to display.
NOTE:
You can sort the Radio List by every field except the Delete field. Click the column label to sort the list
by the selected field. The column label allows you to toggle between the various sort options specific to
each field.
Adding radios to a load balancing group
Radios added to a load balancing group belong to the fit APs managed by the same AC.
To add a radio to a load balancing group:
1. Click the Service tab.