H3C Technologies H3C Intelligent Management Center - Manual (Page 421)

399
NOTE:
You can sort the AC List by every field except the Operation field. Click the column label to sort the list
by the selected field. The column label allows you to toggle between the sort options specific to each
field. AC is always displayed in the first line of the list no matter what sort criterion you have specified.
Querying ACs on the WIDS Config page
WSM provides basic query and advanced query. Basic query criteria include several key parameters
for quick search. Advanced query offers various query criteria for precise match.
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > WIDS Management > WIDS Config.
The ACs list displays all managed ACs in WSM.
3. Perform a basic query:
a. Enter the device label (case-insensitive) or IP address of the AC. WSM supports fuzzy
matching for this field. For example, if you enter 19, all ACs with device labels or IP
addresses containing 19 are queried.
b. Click the Query icon . The AC List displays all ACs matching the query criteria.
c. Clear the Query field, and click the Query icon to display all ACs.
4. Perform an advanced query:
a. Click next to the Query field to expand the Query area. Click it again to hide the Query
area.
b. In the Query area, enter or select one or more of the following query criteria:
{
Device Label—Enter the device label of the AC. WSM supports fuzzy matching for this field.
{
IP Address—Enter the IP address of the AC. WSM supports fuzzy matching for this field.
{
WIDS Status—Select a WIDS state for the AC. Options are Unlimited, Enable, and Disable.
{
Vendor—Select a vendor for the AC. Options are Unlimited, H3C and HP.
c. Click Query. The AC list displays all ACs matching the query criteria.
d. Click Reset to clear the query criteria and display all ACs.
Enabling/Disabling IDS for MSM series ACs
To enable fit APs managed by an AC to detect rogue APs and rogue clients on the network, you must
enable IDS on the AC.
You can enable or disable IDS for MSM series ACs. The IDS feature is always enabled on Comware-
based ACs, and cannot be disabled.
To enable IDS for MSM series ACs:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > WIDS Management > WIDS Config.
The ACs list displays all managed ACs in WSM.
3. Enable or disable IDS for MSM series ACs in batches or one by one: