H3C Technologies H3C Intelligent Management Center - Manual (Page 209)

187
{
Retry Interval(s)—Time that the fat AP must wait before retrying to connect to the primary
authentication server after a connection times out.
{
Retry Timeout(s)—Whether the response timeout timer is enabled, and if yes, the specified
response timeout time.
Secondary RADIUS Server
{
Secondary RADIUS Server—Whether or not to enable the secondary authentication server.
{
Address—IP address or domain name of the secondary authentication server.
{
Secret—Password used for communication between the AC and the secondary authentication
server.
Radio Binding Information
{
Radio Behavior—Radios bound to WLAN: Both Radios, Radio 1 Only, or Radio 2 Only.
5. Click Close.
Adding a WLAN
This function allows you to add a WLAN to the specified fat AP, and bind the WLAN to the radios of
the fat AP.
To add a WLAN to the specified fat AP:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs. The Fat
AP List page displays all fat APs.
3. Click the Operation icon of the target MSM series fat AP.
4. Select WLAN Configuration from the menu.
The WLAN List displays all WLANs on the fat AP.
5. Click Add.
6. Configure basic information for the WLAN:
{
VSC Name—The name of the VSC.
{
SSID—Enter the SSID of the WLAN, a string of 1 to 32 characters. The string can include
digits, letters, special characters such as the following:
− tilde (~)
− at sign (@)
− dollar sign ($)
− percent sign (%)
− caret (^)
− asterisk (*)
− left brace({)
− right brace (})
− left parenthesis (()
− right parenthesis ())
− left bracket ([)
− right bracket (])