H3C Technologies H3C Intelligent Management Center - Manual (Page 596)

574
6. Select a mesh profile ID from the Mesh Profile ID list. The mesh profiles that have been added to
the fat AP are available on the list.
7. Select a channel from the Channels in Use list.
Channel varies with radio type. You cannot set this option to Auto.
8. Click OK.
The operation result page displays the binding result.
Unbinding a mesh profile
After you unbind a mesh profile, you can delete the mesh profile.
Unbinding a mesh profile from radios on a fit AP
1. Click the Service tab.
2. Select WLAN Manager > Resource Management > ACs.
3. Click the name link of an AC to enter the device information page.
4. On the Mesh Management menu on the lower right corner of the page, click Mesh Profile
Management.
The Mesh Profile Management page appears.
5. In the Radio List area, click Add.
The dialog box for selecting radios appears.
6. Select the radios from which you want to unbind the profile.
Or, you can set search criteria to query radios before selecting them, as follows:
a. Enter search conditions for the following:
− AP Label
− AP Name
− Serial Number
− Radio Type
− Admin Status
− Mesh Profile ID
− Location.
An empty field or a field that is set to Unlimited does not serve as a query criterion.
b. Click Query.
The radio list displays all matching radios.
Click Reset to clear the query criteria and display all radios.
7. Click OK.
The selected radios are displayed.
8. In the Mesh Profile List area, select the mesh profile.
9. Click Unbind Mesh Profile.
The operation result page displays the result.
Unbinding a mesh profile from radios on a fat AP
1. Click the Service tab.