H3C Technologies H3C Intelligent Management Center - Manual (Page 479)

457
− Pattern value—This field is available only when the match criterion is Equal to.
− Min. Pattern Value—This field is available only when the match criterion is Between or
Greater than.
− Max. Pattern Value—This field is available only when the match criterion is Between or
Smaller than.
7. Click Back to go back to the sub rule list.
Querying sub rules
To perform a basic query:
1. Click the Service tab.
2. Select WLAN Manager > WIPS Management > Virtual Security Domain from the navigation tree.
3. Click the Signature Policy tab.
4. Click Signature Rule.
5. Click Sub Rule.
The sub rule list displays all sub rules.
6. Enter a partial or complete name of the sub rule in the query field on the upper right corner.
7. Click the Query icon . The sub rule list displays all sub rules matching the query criteria.
8. Clear the Query field, and click the Query icon to display all sub rules.
To perform an advanced query:
1. Click the Service tab.
2. Select WLAN Manager > WIPS Management > Virtual Security Domain from the navigation tree.
3. Click the Signature Policy tab.
4. Click Signature Rule.
5. Click Sub Rule.
The sub rule list displays all sub rules.
6. Click the Advanced icon to the right of the query field.
7. Set the query criteria:
{
Sub Rule Name—Enter the sub rule name. WSM supports fuzzy matching for this field.
{
AC—Select the AC where the signature rule is configured. If you select All, this field does not
serve as a query criterion.
8. Click Query.
The sub rule list displays all sub rules matching the query criteria.
9. Click Reset to clear the query criteria and display all sub rules.
Adding a sub rule
1. Click the Service tab.
2. Select WLAN Manager > WIPS Management > Virtual Security Domain from the navigation tree.
3. Click the Signature Policy tab.
4. Click Signature Rule.
5. Click Sub Rule.
The sub rule list displays all sub rules.