H3C Technologies H3C Intelligent Management Center - Manual (Page 385)

363
− Area
− Building
− Floor
− Room.
{
Hotspot—Set whether the location view is a GIS hotspot. The hotspot manages all APs
belonging to it. It cannot contain any sub-location views. Sub-location views can only be
added to the location views with no hotspot associated.
You must configure extended properties have been defined for a hotspot. For more
information, see "
Configuring extended properties for hotspots associated with location
views ."
{
Automatically Add AP—Select this option to automatically add APs to the location view. You
must configure an AP matching rule:
− Start IP Address/End IP Address—Enter the IP address range for the AP. The start IP
address and the end IP address must be in the same format.
− AP Model—Enter the AP model.
− AP Name—Enter the AP name.
Click Add to add more AP matching rules. Click Delete to delete an AP matching rule.
5. Click OK.
Modifying a location view
This function enables you to modify the name and type of a location, and select whether to set the
location as a hotspot.
NOTE:
A location view that contains sub-location views cannot be set as a hotspot.
To modify a location view:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > View Management > Location Views.
The Location List displays all location views.
3. Click the Modify icon for the target location view.
The Modify Location page appears.
4. Set the location view parameters as needed.
For more information, see "
Adding a location view ."
5. Click OK.
Deleting a location view
Deleting a location view deletes all of its sub-location views. The devices on the location view and its
sub-location views are removed from the views but are not deleted from WSM.
Deleting a location view associated with a GIS hotspot deletes the corresponding hotspot on GIS view.
To delete a location view: