Modifying the vlan to which mesh interfaces belong, Deleting mesh interfaces, Deleting mesh – H3C Technologies H3C Intelligent Management Center User Manual
Page 607: Interfaces
585
{
Port Security Mode—This field is set to PSK and cannot be modified. Only PSK is supported.
PSK is the negotiation key between two APs. You must configure the same PSK on the local
and peer APs.
{
Key Type—Select a type from the list. Options are 11Key and a blank.
{
PSK Mode—Select a PSK mode. Options are pass-phrase, raw-key, and a blank.
{
PSK—Enter a PSK string. If PSK Mode is set to a blank option, do not enter any value.
7.
Click OK.
The operation result is displayed. If the operation fails, reasons for the failure are displayed.
8.
Click Back to return to the Mesh Interface Management page.
Modifying the VLAN to which mesh interfaces belong
You can modify the VLAN to which one or more mesh interfaces belong. If the interface has been
bound to a mesh profile, you cannot modify the VLAN to which the interface belongs. Unbind the
interface from the mesh profile before modifying the VLAN. For more information about unbinding an
interface from a mesh profile, see "
To modify the VLAN to which a mesh interface belongs:
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Resource Management > ACs or WLAN
Manager > Resource Management > Fat APs.
3.
Click the device label of an AC or fat AP to enter the device information page.
4.
On the Mesh Management menu on the lower right corner of the page, click Mesh Interface
Management.
The Mesh Interface Management page appears.
5.
Use one of the following methods to enter the Modify VLAN page:
Method 1—Modify the VLAN for one interface:
a.
Click the Operation icon
of a mesh interface.
b.
Select
Modify VLAN from the menu.
Method 2—Modify the VLAN for multiple interfaces.
a.
Select the mesh interfaces for which you want to modify the VLAN.
b.
Click Modify VLAN.
6.
Select a VLAN ID from the VLAN list. VLANs created on the device are available on the list.
7.
Click OK.
The operation result is displayed. If the operation fails, reasons for the failure are displayed.
8.
Click Back to return to the Mesh Interface Management page.
Deleting mesh interfaces
You can delete one or more mesh interfaces. If the interface has been bound to a mesh profile, you
cannot delete the interface. Unbind the interface from the mesh profile before deleting the interface.
For more information about unbinding an interface from a mesh profile, see "
To delete a mesh interface: